Most Recent Cisco 500-220 Exam Dumps

This is because the alert mentions 802.1X failure, which is a network access control method that is used with WPA2-enterprise and RADIUS servers1.

This question is related to the topic ofWireless Access Points Quick Startin the Cisco Meraki documentation. You can find more information about this topic in theWireless Access Points Quick Startarticle or theUsing the Cisco Meraki Device Local Status Pagepage.

https://documentation.meraki.com/Architectures_and_Best_Practices/Auto_VPN_Hub_Deployment_Recommendations

This is the number of tunnels that each hub needs to support in a hub-and-spoke Auto VPN deployment with two NAT-mode hubs with dual uplink connections and 50 remote sites with a single uplink connection.This can be calculated by using the formula for the hub tunnel count in a hub-and-spoke topology1:

Hub Tunnel Count = (H x (H - 1) / 2 x L1) + (H x S x L1 x L2)

Where H is the number of hubs, S is the number of spokes, L1 is the number of uplinks for the hubs, and L2 is the number of uplinks for the spokes. In this case, H = 2, S = 50, L1 = 2, and L2 = 1. Therefore,

Hub Tunnel Count = (2 x (2 - 1) / 2 x 2) + (2 x 50 x 2 x 1) Hub Tunnel Count = (2 x 1 / 2 x 2) + (200 x 2) Hub Tunnel Count = (2 / 2 x 2) + (400) Hub Tunnel Count = (1 x 2) + (400) Hub Tunnel Count = 2 + 400 Hub Tunnel Count =402

This question is related to the topic ofAuto VPN Hub Deployment Recommendationsin the Cisco Meraki documentation. You can find more information about this topic in theAuto VPN Hub Deployment Recommendationsarticle or theMeraki Auto VPN General Best Practicespage.

This can be determined by looking at the concentrator routing table and finding the entry for the destination IP 10.116.32.4. The next hop for this entry is the Auto VPN peer ''Store 1532 -- appliance''.

This question is related to the topic ofImplementing Dynamic Routing Protocolsin the Engineering Cisco Meraki Solutions (ECMS) official training documentation. You can find more information about this topic in theECMS v2.2 Course Overviewor theECMS1 v2.1 Course Overview.

SM Sentry enrollment can be enabled on any MR network via the Splash page section of the Wireless > Configure > Access control page. https://documentation.meraki.com/MR/MR_Splash_Page/Systems_Manager_Sentry_Enrollment

The correct answer is B and D. These are the two methods of targeting and applying management profiles to System Manager clients, according to the [System Manager: Getting Started] article. The article explains that:

Defining the scope: This method allows you to target devices based on their network, tag, or owner. You can define the scope of a profile from the Systems Manager > Manage > Settings page or from the Systems Manager > Monitor > Overview page.

Using device tags: This method allows you to target devices based on their attributes, such as OS, model, location, or user. You can use device tags to create dynamic groups of devices that share common characteristics. You can apply device tags from the Systems Manager > Monitor > Devices page or from the Systems Manager > Manage > Tags page.