Trusted Worldwide Questions & Answers
Most Recent VMware 3V0-42.20 Exam Dumps
Prepare for the VMware Advanced Design VMware NSX-T Data Center exam with our extensive collection of questions and answers. These practice Q&A are updated according to the latest syllabus, providing you with the tools needed to review and test your knowledge.
QA4Exam focus on the latest syllabus and exam objectives, our practice Q&A are designed to help you identify key topics and solidify your understanding. By focusing on the core curriculum, These Questions & Answers helps you cover all the essential topics, ensuring you're well-prepared for every section of the exam. Each question comes with a detailed explanation, offering valuable insights and helping you to learn from your mistakes. Whether you're looking to assess your progress or dive deeper into complex topics, our updated Q&A will provide the support you need to confidently approach the VMware 3V0-42.20 exam and achieve success.
The questions for 3V0-42.20 were last updated on Feb 20, 2025.
- Viewing page 1 out of 11 pages.
- Viewing questions 1-5 out of 57 questions
An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.
This information was gathered during a workshop:
There are six hosts and hardware has already been purchased.
Customer is planning a collapsed Management/Edge/Compute cluster.
Each host has two 10Gb NICs connected to a pair of switches.
There should be no single point of failure in any proposed design.
Which virtual switch design should the architect recommend to the organization? (Choose the best answer.)
Which three IPv6 features are supported in an NSX-T Data Center design? (Choose three.)
An architect is helping an organization with the Logical Design of a Layer 2 bridging solution.
This information was gathered during the Assessment Phase:
Workloads are running on ESXi hosts.
Workloads are running on KVM hosts.
Workloads on hypervisors should use bridging services.
VLAN 50 is used for Tier-0 uplink connectivity.
Which selection should the architect include in their design? (Choose the best answer.)
An architect is helping an organization with the Logical Design of an NSX-T Data Center solution. During discussions about centralized services NAT running on Tier-1 or Tier-0 Gateway, the customer made these requests:
Services contain stateful services.
Services should be in high availability mode.
Which two selections should the architect include in their design? (Choose two.)
Stateful services: Require HA mode configured as Active-Standby
Stateless services: Require HA mode configured as Active-Active
You can create different NAT rules:
* Source NAT (SNAT) translates the source IP of the outbound packets to a known public IP address so that the application can communicate with the outside world without using its private IP address. SNAT also tracks the reply.
* Destination NAT (DNAT) enables access to internal private IP addresses from the outside world by translating the destination IP address when inbound communication is initiated. DNAT also takes care of the reply. For both SNAT and DNAT, users can apply NAT rules based on the 5-tuple match criteria.
* Reflexive NAT rules are stateless access control lists (ACLs) that must be defined in both directions. These rules do not track the connection. Reflexive NAT rules are applied when stateful NAT cannot be used. For example, when a Tier-0 gateway is running in active-active equal-cost multipath (ECMP) mode, you cannot configure stateful NAT because asymmetrical paths might cause issues.
Which two benefits can be achieved using in-band management of an NSX Bare Metal Edge Node? (Choose two.)
Unlock All Questions for VMware 3V0-42.20 Exam
Full Exam Access, Actual Exam Questions, Validated Answers, Anytime Anywhere, No Download Limits, No Practice Limits
Get All 57 Questions & Answers